Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 33)

320IS Plus Installation Manual - Configuration 27
3.2.3 Calibration Menu
Figure 3-3. Calibration Menu
CALIBR Menu
Parameter Choices Description
Level 2 submenus
WZERO — Display and edit the zero calibration A/D count value.
DO NOT adjust this value after WSPAN has been set!
WVAL — Display and edit the test weight value.
WSPAN — Display and edit the span calibration A/D count value.
REZERO — Press ENTER to remove an offset value from the zero and span calibrations.
Use this parameter only after WZERO and WSPAN have been set. See Section 4.1 on
page 41 for more information about using this parameter.
Table 3-4. Calibration Menu Parameters
WZERO
*CAL*
Display and edit
zero calibration
A/D count value
Display and edit
test weight value
WV AL
*CAL*
Display and edit
span calibration
A/D count value
WSPAN
* CAL*
Press Enter to
remove offset from
zero and span
calibrations
REZERO
XXXXXXX XXXXXXX XXXXXXX XXXXXXX VERS ALGOUT DIGIN PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT XXXXXXX SETPNT