SINGER 9970 - Manual (Page 14)

14
BOBBIN SETTING
Be sure to use only SINGER (Class 15) bobbins in
this machine.
A. REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and remove
the bobbin cover.
2. Lift up the bobbin from the machine.
B. SETTING SPOOL OF THREAD ON SPOOL
PIN
1. Pull up the left end of spool pin and set the spool
of thread on spool pin so that the thread unrolls
from the front of the spool.
2. Set the spool cap on spool pin as far as it will go.
a: Reverse spool cap direction according to the
size of spool.
b. Use the small spool cap when you use cross
wound thread. Leave small opening between cap
and spool as illustration.
C. WINDING THE BOBBIN
1. Hold thread in both hands and hook thread to the
guide from rear opening.
2. Bring thread forward and pass through the thread
guide plate from right to left.
3. Bring thread to the right and pass thread to the
thread guide from under side. Pass through under
tension disc in counter-clockwise direction.
4. Insert thread through hole in bobbin and place the
bobbin on bobbin winder spindle. Push bobbin to
the right to engage bobbin winder. LCD will
indicate the bobbin winding mode.
5. Hold the end of the thread and start the machine
by pressing the start/stop button or pressing the
foot controller pedal.
6. After the bobbin winds a few turns, stop the
machine by pressing the start/stop button or
releasing the foot controller pedal. Cut the thread
near hole.
7. Start the machine again.
8. The bobbin winding will stop automatically when
bobbin is full. (Release the pedal.)
9. Push the bobbin and spindle to the left.
10 Remove the bobbin from the spindle and cut the
thread.