SINGER 7025 - Manual (Page 12)

5 Stitch Sewing Machine
Changing the needle plate (A), (C)
Your machine comes with the General Purpose
Needle Plate (A) attached. The Straight Stitch Needle
Plate (C) may be purchased at your sewing center
and can be attached as follows:
* Raise needle and presser foot.
* Open slide plate.
* Lift up needle plate from right corner and slide out
from under foot.
* To replace needle plate, slide it under pin (1) and
push it firmly to the left
* Press down until it snaps into place.
Attaching the feed cover (F)
The feed cover is used to keep the feed from moving
the fabric when attaching a button, darning or sewing
free-motion embroidery. To attach it, follow the
directions below:
* Raise needle and presser foot.
* Open slide plate.
* Slide feed cover on top of needle plate, pressing
tabs (1) and (2) into holes.
* Close slide plate.
* To remove, open slide plate and lift front edge of
cover; pull it away.
Removing the extension table
Free arm sewing makes it easier to sew hard-to-reach
areas.
To change machine for free arm sewing, lift right edge
(1) of extension table, slide it to the left and off the
machine.
To replace the extension table, slide it to the right
keeping it even with the free arm, until the tabs on the
right lock into place.
12