SINGER 44S CLASSIC HEAVY DUTY - Manual (Page 53)

Raise the presser bar (a) with the presser foot lifter. Loosen
or remove the presser shank screw. Line up the opening in
the shank with the opening on the presser bar and then
tighten the screw. (1)
Lower the presser foot shank (b) using the presser foot lifter,
until the cut-out (c) is directly above the pin (d). (2) The
presser foot (f) will engage automatically.
Raise the presser foot using the presser foot lifter. (3)
Raise the lever (e) and the foot disengages.
Attach the edge/ quilting guide (g) in the slot as illustrated.
Adjust as needed for hems, pleats, quilting, etc. (4)
Turn power switch to off ("O") when carrying out any of
the above operations!
Attaching the presser foot
Removing the presser foot
Attaching the edge/ quilting guide
Attention:
1 2
3 4
a
c
d
e
f
b
b
a
e
g
46
Attaching the Presser Foot Shank EN