Thetford 19623 - Wiring Harness - Manual (Page 2)

3. Snap large white Multi-wire Connector Housing, with
raised housing ridge facing inside of toilet, into place.
4. Replace Rubber Boot.
5. Connect Motor Leads to Wiring Harness (green to green
and yellow to yellow).
6. If you have removed the Sound Deadening Insulation,
replace it. Secure with Velcro TM strap provided.
7. Use Nylon Tie to resecure Wiring Harness to Overflow
Tube.
Part #19623
Wiring Harness
Continued
To Replace Toilet To Floor
1. Secure new Closet Flange Seal, lip side up, to Toilet.
2. Position Toilet over flange.
3. Reconnect Water Supply Line.
4. Reconnect 12-volt power supply to Toilet.
5. Reconnect RV’s power supply to the Toilet.
6. Turn on RV’s water supply. Press Toilet flush button to
close blade and to flush test.
7. Secure to floor with Lag Screws. Tighten.
8. Resecure Bolt Caps.