Vintage Cellars Platinum MIni Split Tech Manual - Manual (Page 13)

www.whisperkool.com | Page 11
PREPARING AND INSTALLING THE
EVAPORATOR UNIT (FAN COIL UNIT)
• Drill
• 5/32” Drill Bit
• 1/4” Socket Drill Bit
• 1/4” Wrench
• Phillips Head Screwdriver
• Tape Measure
• Brazing Torch
• Drywall Saw
• Ladder
• Level
• Pliers
• Pencil
Required Tools:
1. Pull apart the Filter Grille from the Evaporator
Unit.
2. Cut the Zip Tie holding the circular connectors
and wires on the rear left corner of the interior of
the unit.
3. Unscrew the nut attached to the Circular
Connector (Bottle Probe Input.)
4. Install the Circular Connector (Bottle Probe
Input) in The hole located at the bottom of the
housing.
NOTE: From a frontal perspective, the Circular
Connector is located in the rear-left corner of the
bottom of the unit.
5. Secure the Circular Connector (Bottle Probe
Input) to the unit using the provided nut (the
Rubber Washer should remain inside the unit).
RUBBER WASHER
NUT
UNIT PANEL
CIRCULAR CONNECTOR/
BOTTLE PROBE INPUT
HOLE FOR CIRCULAR CONNECTOR
(BOTTLE PROBE INPUT)
DRAIN PAN