Vintage Cellars Napa Winekeeper 4 bottle - Manual (Page 3)

3
Unpacking
While unpacking your unit, please check to make sure that all parts are included and undamaged. Please
call WineKeeper at 855.511.5113 if there are any problems. YOU MUST REPORT damage immediately
and missing parts within 7 days of receiving your unit.
These parts are included with your unit:
• Appropriate number of faucets for your unit
• Regulator (for use with refillable nitrogen or argon cylinder)
• Cleaning kit
• Instructions
Setting Up Your Unit
Your WineKeeper wine dispensing unit must be installed on a flat, level surface with vented space of at
least 3" behind, 1" on the sides, and 12" above the unit for proper ventilation. Once your unit is properly
located, attach the faucets. Taking care to align the threads properly, place the faucet on the thru-wall and
tighten the wing nut.
You may now plug the units’ power
cord into 110 volt grounded electrical
outlets. Be sure to plug in all electrical
cords:
• 4-bottle units = 1 plug
• 8-bottle units = 2 plugs
An 8 foot gas supply line is included
with your unit. The supply line
includes a quick connect fitting that
connects to the regulator supplied with
your unit. USING A REGULATOR
OTHER THAN THE ONE
SUPPLIED WILL VOID THE
WARRANTY. Your nitrogen/argon
cylinder can be placed anywhere
convenient—vertical or horizontal.
DO NOT TAMPER WITH OR
REMOVE THE QUICK-
DISCONNECT TO COUPLE YOUR GAS SUPPLY
LINE AND REGULATOR, THIS WILL ALSO VOID THE WARRANTY.