Vinten Radamec Fusion APS - Manual (Page 12)

10
Configuration
Creating a Landmark Map
The APS user interface is used to scan the locations of the reflective
targets in the studio to create a landmark map. This map is then stored
by the APS scanner and used to provide accurate pedestal positional
data anywhere on the studio floor.
Starting Up
1.
Connect the configured computer to a spare network port on the
APS scanner using an Ethernet cable.
2. Power up the pedestal. If the pedestal has previously been used
and has pre-stored shots referenced to a floor target, perform the
standard floor targeting procedure.
3. Power up the APS unit.
The LCD display will
initially show a boot up
screen and then change to
the main display screen.
Positional values are
displayed with a # symbol
indicating that mapping is
required.
4. Launch the web browser and type http://192.168.1.70 in the
address bar.
5. The user interface
home page opens, with
information displayed
about the firmware and
hardware versions of
the APS scanner unit.
Links to the other main
pages of the user
interface are also
provided here.