Document Outline

• Contents
• Symbols
  • Documentation symbols
  • Regulatory symbols
• About warnings and cautions
  • Warnings and cautions
  • Customer responsibility
  • Safety precautions
  • Status/Error messages
    • Display messages
    • Indicator lights (LEDs)
• Introduction
  • Introduction
  • OAE functionality
  • Distortion product otoacoustic emissions
  • OAE emission results
  • Frequency Range tested
  • Results storage and reporting
  • Sensitivity and specificity
• Setup
  • Unpack the system
  • Cradle
  • Charge the battery
    • Battery status indicator
    • Charge the battery using the USB port
    • Charge the battery using the cradle
  • Install the probe
  • Attach the probe tube
  • Eartips
    • Attach and remove the eartips
  • Probe holder
    • Attach the probe holder
  • Clock settings
    • Access the clock menu
    • Change the clock mode
    • Change the date and time
• Device settings
  • Control panel
  • Access menus
  • Device settings
  • Bluetooth® device pairing
    • Pair the screener and Bluetooth device
    • Select a Bluetooth device
  • Clear test results
  • Minimum amplitude
  • Change the language
  • Reset to default
    • Reset to default settings
• Operating instructions
  • Turn on the screener
  • Automatic shutdown interval
    • Change the automatic shutdown interval
  • Main menu
  • Select the test protocol
  • Prepare the patient for testing
  • Start a test
  • AutoStart probe check
    • Troubleshoot the AutoStart probe check
• Test results
  • Test phase
  • Graph styles
    • SNR bar graph view
    • Value graph view
    • Change graph style
  • Test techniques
    • Test an infant
    • Test children with pressure equalizer tubes
  • Noise sources
  • View results
    • Repeat an inconclusive test
• Manage results
  • Results storage and reporting
  • Save/Store test results mode
    • SAVE L/R mode
    • SAVE 250 mode
    • Change the SAVE mode between SAVE L/R and SAVE 250
    • View patient names
  • Delete test results
    • Delete results in SAVE L/R mode
    • Delete results in SAVE 250 mode
  • Connect the screener to a computer
  • Connect the screener cradle to a computer
  • Connect the screener to a computer using Bluetooth
  • Pair the screener and Bluetooth device
  • Print to a thermal printer
• Understand printed results
  • DPOE printout
  • Rounding results
• Clean and disinfect
  • Clean and disinfect
• Maintenance
  • General maintenance
  • Replace the probe tube
  • Troubleshooting
  • Repairs
• Standards and compliance
  • General compliance and standards
• Appendices
  • Appendix A: Specifications
    • Probe specificiations
    • Instrument specifications
    • Power supply specifications
    • Environmental requirements
  • Appendix B: Flowchart: Measurement
  • Appendix C: Test sequence
    • AutoStart phase
    • Calibration phase
    • Test phase
    • Variations in the SNR Estimate
  • Appendix D: Pass/Refer criteria
  • Appendix E: Configurations and test protocols
  • Appendix F: Approved options