Cub Cadet SLTX1054 - Manual (Page 28)

To place the new belt begin by routing the belt around the 5.
two outer spindle pulleys, then around the front spindle
pulley as shown in Fig. 7-8.
Route the belt around the two deck idler pulleys as shown 6.
in Fig. 7-8.
Retighten the belt keeper rod loosened earlier.
7.
Remount the belt guards removed earlier. 8.
Re-install the deck making sure the belt remains routed 9.
around the pulleys as instructed.
Pull the right side of the belt and place the narrow V side of
10.
the belt into the PTO pulley. See Fig. 7-9.
While holding the belt and pulley together, rotate the 11.
pulley to the left (See Fig. 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
Front Spindle
Pulley
Outer Spindle
Pulleys
Deck Idler
Pulleys
Figure 7-8
PTO Belt
Rotate
Pulley
Figure 7-9
28 s
ectiOn
7— s
ervice