Welch Allyn Connex Vital Signs Monitor Base Set - Quick Reference Guide - Manual (Page 4)

Add a patient to the patient list
(not connected to central station)
1. Touch the Patients tab.
2. Touch Add.
3. Touch and then enter patient information.
4. Touch Next to cycle through the patient data fields.
Note You can use a barcode scanner to enter a patient ID in the Patient ID
field. Touch in the Patient ID field, scan the barcode, and
touch OK.
5. Touch OK to return to the Home tab.
Configure parameter options
1. Touch the Settings tab.
2. Touch the Setup tab.
3. Touch the parameter(s) in the vertical tab you want to modify.
(Touch the
to scroll through the list as needed.)
4. Modify settings for each parameter as desired.
The new settings take effect immediately.
Clean the monitor or stand
1. Power down the monitor.
2. Wipe the equipment with one of the following:
• cloth dampened with 70 percent isopropyl alcohol
• cloth dampened with 10 percent chlorine bleach solution
(rinse off bleach with a damp cloth)
Caution When cleaning the device, avoid using cloths or solutions
that include quaternary ammonium compounds (ammonium chlorides)
or glutaraldehyde-based disinfectants.
3. Allow the equipment to dry for 10 minutes before use.
© 2013, Welch Allyn, Inc. All rights reserved. Mat. No. 720693, 80018643 Ver. A 104703