Welch Allyn PartnerConnect Software - Installation Guide User Manual
Page 16
•
Agent is installed on networked computer: Select this option if the agent device
is on the same local network as the deployment utility computer. If you select this option,
type or select the host name or IP address of the agent device. The Host field accepts
IPv4 and IPv6 addresses as well as alphanumeric characters for a machine name.
•
Agent is connected via serial cable: Select this option if the agent device is
connected to the deployment utility computer by a serial cable. If you select this option,
type or select the serial COM port.
4. Click OK to connect to the agent.
5. Click Enterprise Servers in the left pane, then select the Proxy Servers tab.
6. Select the appropriate proxy setting for the site.
•
Enable Proxy Auto-Configuration: The agent communicates directly with the
enterprise server; it does not go through a proxy server.
•
Enable HTTP Proxy: The script identifies the HTTP proxy server IP address and port.
•
Enable SOCKS Proxy: The script identifies the SOCKS proxy server IP address and
port.
7. Save the settings to the agent. After you add or edit settings using the deployment utility, you
must send the changed settings information to the agent and restart the agent.
a. Click Deploy Changes to Agent.
12 Configure PartnerConnect with proxy settings
PartnerConnect® software