Zippy RPU-6400F-RV2S - Manual (Page 19)

INPUT CHARACTERISTICS: RPX - 4400 / 5400
* VOLTAGE : 95 - 132 VAC OR 190 - 264 VAC SWITCHABLE
* FREQUENCY : 47 - 63 HZ
* INPUT CURRENT : 4.0 A / 2.0 A PER UNIT (PARALLEL)
8.0 A / 4.0 A ( ONE POWER SUPPLY )
* INRUSH CURRENT : 40 A MAX. FOR 115 VAC,
80 A MAX. FOR 230 VAC ( ONE POWER SUPPLY)
OUTPUT CHARACTERISTICS :
OUTPUT CURRENT REGULATION OUTPUT
MIN. (A) MAX. (A) LOAD LINE
7.0 36/72*
3.0** 20/40**
12 2.5 24/48* + / - 3% + / - 1% 100 mV
-5V 0 1 + / - 10% + / - 1% 150 mV
-12 0 1 + / - 10% + / - 1% 150 mV
3.3*** 3 20 + / - 3% + / - 1% 50 mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. (P-P)
5 50 mV + / - 3% + / - 1%
* : PEAK FOR 1 MINUTE ** : UNDER WITH 3.3 V OUTPUT CONDITION
*** : 3.3 OUTPUT IS OPTIONAL
ACTUAL POWER USAGE SHALL NOT OVER THE TOTAL OUTPUT POWER
THE MAX. TOTAL OUTPUT OF +5V AND +3.3V IS 160W.
* TEMPERATURE RANGE : OPERATING 0
°
C --- 50
°
C, STORAGE -20
°
C --- 80
°
C
* TRANSIENT RESPONSE : OUTPUT VOLTAGE RETURNS IN LESS THAN 1 ms
MAX. FOLLOWING A 50 % LOAD CHANGE
* HOLD UP TIME : 16 ms MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
* DIELECTRIC WITHSTAND : INPUT TO FRAME GROUND 1500 VAC FOR 1 SEC.
* HUMIDITY : 10 - 90 % RH
* EFFICIENCY : 70 % TYPICAL AT FULL LOAD
* POWER GOOD SIGNAL : ON DELAY 100 ms TO 500 ms, POWER FAIL
≥ 1 ms
* OVERLOAD PROTECTION : 110 - 150 % MAX. ( POWER UNIT )
* OVER VOLTAGE PROTECTION : + 5V OUTPUT: 5.5 V --- 6.5 V
+ 12V OUTPUT: 13.5 V --- 15.5 V ( OPTIONAL )
* SHORT PROTECTION
* ALARM METHOD: 1) AUDIO ALARM 2) FAULT LED 3) POWER DEFECTIVE SIGNAL
* EMI NOISE FILTER: AC INPUT LINE FILTER FOR FCC CLASS B ON EACH UNIT
* SAFETY: EACH POWER UNIT ARE UL / CSA / TÜV APPROVAL
* HOT-SWAPPABLE & HOT-PLUGGABLE CAPABILITY
* DIMENSION : REFER THE DRAWING
* REDUNDANCY: BALANCED SHARE LOAD METHOD
20