Zippy RPU-6400F-RV2S - Manual (Page 21)

1.6 INSTALLATION & TESTING
Turn off the main on/off switch and the individual power supply's on/off switches ( on
the rear side ).
Mount the power supply in the case using the mounting hardware that is included, the
mounting holes in the power supply should match up with those in the case.
Attach the six-pin connectors ( 20-pin connector for ATX system ) to the motherboard by
following the motherboard instructions, there are different kinds of pinouts in both the power
supply and motherboard, they should match each other, otherwise the connection will cause
undetectable harmness.
Attach all the remaining power supply connections to the various peripherals as needed,
these connectors are "keyed", so there will be only one possible way to connect them.
NOTE: The power unit is designed for AT system or ATX system. Before using the power unit,
please aware the following instruction; otherwise, the power supply may not work
properly.
There is a wire lead accompany with the DC wires.
1. If the power unit is for AT system, please connect the connector.
2. If the power unit is for ATX system, then please do not connect the
connector. Just leave it alone.
Soft Power Function:
If you are going to use soft power function, the power has to be always wired ON. You may
either keep the power switch turned on, refer to figure A (Note: The power supply’s main on / off
control is designed by using DC current. Please ensure to connect the two wires to the same
vertical side), or just to figure B. Then the power supply can be turned on by the screw-on
connector, refer to figure B. Then the power supply can be turned on by the soft power function
of the motherboard only
.
22