Crestron electronic AM/FM/TV Tuner - Manual (Page 35)

Crestron ST-TUNE Integrated AM/FM/TV Tuner
Operations Guide - DOC. 5833A Integrated AM/FM/TV Tuner: ST-TUNE
••
31
10. Enter the following key sequence to (as previously defined for the
product) ESC, X, R, ID, ENTER. On the front panel of the unit, the
PRE, TUNE, SRCH plus either the AM, FM, WX, or TV LEDs will be
illuminated. If the return ID command is executed from the Viewport,
the display will show “BOOT”.
11. As shown below, select File Transfer | General File Transfer |
ASCII Upload from the Viewport menu.
Select ASCII Upload
12. As shown below, browse to the firmware directory, select the
downloaded loader (HEX) file and click Open. The transfer will
complete in approximately 3-1/2 minutes.
Select Loader (HEX) File
13. Select Diagnostics | Report Network Devices in the Viewport
(alternatively, depress F4) and observe Viewport return display show
“BOOT”.
NOTE: When the external power pack is disconnected from the ST-TUNE,
operating power will automatically switch to Cresnet power supplied via the NET
connector(s). To remove power from the unit, make sure both external power pack
and NET connector(s) are removed.