Before you begin, Installing the card – Dell PowerEdge 2600 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This document explains how to install your system’s optional SCSI daughter card to enable
split operation of the SCSI backplane.
/K CAUTION: The power supplies in this system may produce high voltages and
energy hazards, which can cause bodily harm. Only trained service technicians
are authorized to open the system and access any of the components inside the
system. Read and follow all safety precautions in your
System Information
document.
/K CAUTION: The system may have more than one power supply cable. To reduce
the risk of electrical shock, turn off the system and disconnect all power supply
cables before servicing the system.
O
NOTICE :
To avoid data loss, back up all data on the hard drives before installing the
SCSI daughter card and changing the drive configuration.
Before You Begin
O
NOTICE:
Befo re installing the SCSI daughter card, you must update the BIOS to the
latest version.
Before shutting down the system prior to installing the SCSI daughter card, you must
perform these preliminary steps:
1 Record the system configuration settings.
View the system configuration screens in the System Setup program and make a record
of these settings. See the system User's Guide for instructions on using the System
Setup program.
2 Update the BIOS.
Update the system with the latest version of the BIOS, available at the Dell | Support
website at support.dell.com.
Installing the Card
1 Unpack the SCSI backplane daughter card kit.
2 Remove the bezel.
See "Removing the Bezel" in the Installation and Troubleshooting Guide.
3 Turn off the system, including any attached peripherals, and disconnect the system
from the electrical outlet.
I n s t a l l i n g t h e S C S I B a c k p l a n e D a u g h t e r C a r d |
1-1