Canon LV-7245 - Manual (Page 12)

4
1. Introduction
ᕣ Part Names of the Projector
POWE R
VID EO
S-VIDEO
COMPUTER-1
COM PUTER-2
WA RN ING
LAM P R EPL AC E
AUTO PC
VO L -
VO L +
ZO OM
FO CUS
AC IN
VOL -
VOL +
ZOOM
FOCU S
S-VIDEO IN
MO NO
MO NO
VID EO IN L AUD IO IN R
ANA LO G IN-1
ANA LO G IN -2
AUD IO O UT
L AUD IO IN R
SER VICE PO
RT
AU DIO IN
PO W ER
VID EO
S-VIDEO
COM PUTER -1 COM PUTER -2
WA RNING
LAM P REPLACE
AUTO PC
AC IN
Zoom Lever
(See page 24 )
Controls
(See page
6 )
Lens
Lens Cap
Be sure to remove the lens cap
during projection. The cap can
deform or fire can occur.
Built-in Security Slot ( )*
Focus Ring
(See page 24 )
Adjustable Tilt Foot Lever
(See page
23 )
Adjustable Tilt Foot
(See page
23 )
Remote sensor
(See page 10 )
Ventilation (inlet) / Filter Cover
(See page
47 )
Do not block this vent.
Troubles or fire can result.
Ventilation (inlet)
Front/Top
AC Input
Connect the supplied power cord’s two-pin plug here, and
plug the other end into an active wall outlet. (See page
19 )
Main Power Switch
When you plug the supplied power cord into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(See page
20 )
Remote sensor
(See page
10 )
Terminal Panel
(See page 7 )
Monaural Speaker
(1W)
Rear
* This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of
Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Ventilation (outlet)
Heated air is exhausted from here.
Do not block this vent. Troubles or
fire can result.