COBY electronic DVD-53 - Manual (Page 17)

Page 1 Coby Electronics Corporation www.cobyusa.com Page 1 Page 1 Coby Electronics Corporation www.cobyusa.com Page 1
Component Video Connection (Progressive Scan)
The Component Video jacks of the DVD player are capable of outputting video at
a resolution of 480p (480-progressive). 480p is the native format of DVD video.
The Component Video connection must be enabled in the Setup
menu prior to use. Please refer to the Setup section for more details.
Connect the AC power
cord to the wall outlet
AFTER all other cables
are connected.
Connect only one type
of audio or video
connection at a time to
minimize interference.
2-Channel Audio
Component V
ideo
Red (Cr)
Green (Y)
Blue (Cb)
The DVD player is equipped with component video outputs located on the
rear panel (green/blue/red). If your TV is not capable of accepting a compo-
nent video signal, use the Composite Video or S-Video connections.
You will need to set your TV to the correct input line for use with the DVD
player; depending on the brand of your TV, you may need to press a but-
ton labeled Line, Input, or Video/TV. This will switch the TV from broadcast
reception mode to one of the AV input signals. Some TVs may have more
than one AV input line.
•
•
CONNECTIONS