Important safety instructions – COBY electronic DVD-53 User Manual

Page 4

Advertising
background image

Page 

Coby Electronics Corporation

www.cobyusa.com

Page 

Page 

Coby Electronics Corporation

www.cobyusa.com

Page 

Power Sources: This product should be operated only from the type of power source

indicated on the rating label. If you are not sure of the type of power supply to your

home, consult your product dealer or local power company. For products intended

to operate from battery power or other sources, refer to the operating instructions.

Grounding or Polarization: This product may be equipped with a polarized alternat-

ing-current line plug that has one blade wider than the other. This plug will only fit

into the power outlet in one direction. This is a safety feature. If you are unable to

insert the plug fully into the outlet, try reversing the direction of the plug. If the plug

should still fail to fit, your outlet may be obsolete; contact a licensed electrician to

replace it. Never attempt to defeat the safety purpose of the polarized plug.

Power-Cord Protection: Care must be taken to ensure that power supply cords are

routed so as to avoid being damaged, such as by being walked on or pinched by

items placed upon or against them. You should pay particular attention to cords at

plugs, convenience receptacles, and at the point where they exit from the product.

Protective Attachment Plug: The product may be equipped with an attachment plug

with overload protection. This is a safety feature. See the operating instructions for

replacement or directions to reset the protective device. If replacement of the plug

is required, please consult an authorized service technician, and make sure s/he

has used a replacement plug that has the same overload protection as the original

plug as specified by the manufacturer.

Outdoor Antenna Grounding: If an outside antenna is connected to the product, be

sure the antenna system is grounded so as to provide some protection against volt-

age surges and built-up static charges. Article 810 of the National Electrical Code,

ANS/NFPA 70 provides information with regard to proper grounding of the mast and

supporting structure, grounding of the lead-in wire to an antenna-discharge unit,

13.

14.

15.

16.

17.

IMPORTANT SAFETY INSTRUCTIONS

Advertising