Dell Inspiron 5000 - Manual (Page 6)

When Removing or Installing Memory Modules
Before you remove or install memory modules, perform the following steps
in the sequenee indieated.
V NOTICE: The only time you should ever access the inside of your computer is
when you are installing memory modules.
O NOTICE: Wait 5 seconds after turning off the computer before disconnecting
a peripheral device or removing a memory module to help prevent possible damage
to the system board.
1 Turn off your computer and all attached devices.
2 Disconnect your computer and peripheral devices from their electrical
outlets to reduce the potential for personal injury or shock. Also,
disconnect any telephone or telecommunication lines from the
computer.
3 Remove the battery from the battery bay and, if present, the secondary
battery from the modular bay
4 Ground yourself by touching an unpainted metal surface at the back of
the computer before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the
computer to dissipate any static electricity that might harm internal
components.
In addition, take note of these safety guidelines when appropriate:
• When you disconnect a cable, pull on its connector, not on the cable
itself. As you pull connectors apart, keep them evenly aligned to avoid
bending any pins. Also, before you connect a cable, make sure that
both connectors are correctly oriented and aligned.
• Handle memory modules with care. Don’t touch the components on
a module. Hold a module by its edges.
CAUTION: There is a danger of a new battery exploding if it is
incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used
batteries according to the manufacturer’s instructions.
^ I S a f e t y I n s t r u c t i o n s