Night Optics Panther 336 Thermal Riflescope (336x256 | 50mm) - Manual (Page 10)

OPERATION
9
DISPLAY, MENUS AND SYMBOLOGY
ELEVATION: XX.XXCM
WINDAGE: XX.XXCM
SCOPE SETTINGS
RETICLE SETTINGS
COLOR SCHEME
SERVICE
INFO
2X
1
2
3
4
5
6
7
FIGURE 8: Display Layout & Symbology
DISPLAY LAYOUT AND SYMBOLOGY
[1] Menu
[3] Windage/Elevation Adjustments
[5] Shutter Calibration (Auto)
[7] Digital Zoom [2] Windage/Elevation Setting Display
[4] Reticle
[6] Battery Life
Figure 6
ZEROING THE RIFLESCOPE
Before zeroing, ensure that the riflescope is securely mounted to the weapon. In order to properly
zero the thermal riflescope, the target should be heated or have a source of heat behind it so that it
can be seen in the field of view. Third party tools like laser boresighters can be used to assist in this
process.
If the reticle does not appear in the field of view, activate it by entering:
Menu > Reticle Settings > Reticle Type > On
Once weapon has been set up, proceed to the device menu, under “Reticle Settings” (fig. 7), scroll
down to “Elevation and Windage adjust.” Use the directional buttons (fig. 6-2, 3) to align the impact
point of the riflescope with that of the weapon. When a setting changes have been made to
elevation and windage, setting information will appear in the upper left corner of the display (fig.
8-2).
A setup chart is available in the back of this manual to record settings for future reference.