Night Optics Panther 336 Thermal Riflescope (336x256 | 50mm) - Manual (Page 6)

5
OPERATION
BATTERY INSTALLATION
POWERING ON AND OFF
FIGURE 2: Battery Placement
1
2
[1] CR 123 Battery “+” facing up
[2] CR 123 Battery “-” facing up
BATTERY PLACEMENT Figure 2
Loosen the battery cover thumb screw to reveal the battery compartment.
The side wall of each battery compartment is clearly labeled with an instructive diagram illustrating
the direction for which each battery should be inserted.
After installing new batteries, replace the battery cover and tighten the thumb screw.
To power on, press and hold the power button (fig. 1-7) for 3 seconds.
The shutter will click 2 times followed by the Night Optics logo shown momentarily on the display
before showing the thermal image.
To power down, press and hold the power button for 2 seconds.
A message will appear on screen (”POWER OFF Please, release POWER button”) to confirm that
the unit has been properly shut down.
WARNING
• If new CR123 batteries are inserted and the unit does not power up, ensure that the batteries were properly installed.
• Lithium Batteries contain Sulfur dioxide gas under pressure - Do not puncture - Dispose of properly.
• If the unit becomes hot to the touch around the battery compartment, power down and allow to cool before removing
faulty batteries.
• It is not recommended to use mismatched batteries.
• Do not use rechargeable and non-rechargeable batteries at the same time in this device.
• Remove batteries when not in use or when planning to store for long periods of time.
top
bottom