Night Optics Panther 336 Thermal Riflescope (336x256 | 50mm) - Manual (Page 7)

ATTENTION!
• Replacing the riflescope mounting hardware with an untested after-market component will void the warranty.
Improper installation of after-market mounting hardware can lead to permanent damage and/or affect the
units ability to hold zero. Contact Night Optics for assistance.
• If mounting on a “high-recoil” rifle, for safety purposes, allow at least .5” or more additional eye relief.
OPERATION
6
RAIL MOUNTING
The Panther riflescope uses a simple single lever spring loaded picatinny rail mount (fig. 1-10).
To mount the rifle scope, pull the lever to the open position (fig. 4). The spring loaded clamp should
be extended.
Test fit the mount on the rail and attempt to close the lever. If too tight or loose, remove and adjust
accordingly. To adjust the clamp, open the lever, with manually squeeze the mount towards the
closed position (fig. 5).
The lever post with retaining nut will extend out of the mount.
Turn the screw to the left or right to adjust and repeat the test fit procedure until mount lever can be
completely closed but not loose.
Once the mount has been set up to fit the rail properly mount the riflescope for the most comfort-
able eye relief.
FIGURE 3: Closed Mount FIGURE 4: Open Mount
FIGURE 5: Adjustment