Petsafe Big Dog Remote Trainer - Manual (Page 5)

8 US Customer Care Center 1-800-732-2677 www.petsafe.net 9
Receiver Collar: Delivers stimulation or tone on a signal from the Remote Transmitter. It is waterproof.
Antenna: On Little Dog Receiver Collar only, receives the signal that is emitted from the transmitter. An
antenna is not necessary for the Big Dog Receiver Collar to receive the signal.
On/Off Button: Momentarily pressing and holding this button turns the Receiver Collar on and off.
Contact Points: Deliver stimulation to your pet from the Remote Transmitter.
Receiver Indicator Light: Indicates that a button is pressed and also serves as a low-battery indicator.
Red LED: Indicates low battery and when static stimulation button is pressed.
Green LED: Indicates good battery and when tone button is pressed. Also indicates when pairing
mode is complete.
Little Dog Receiver Collar
PDT00-13410
Receiver
Indicator
Light
Battery
Lid
ON/OFF
Button
Contact
Points
Antenna
Big Dog Receiver Collar
PDT00-13411
Receiver
Indicator
Light
Battery
Lid
ON/OFF
Button
Contact
Points
Operating Guide
Prepare the Remote Transmitter
To Insert and Remove the Battery
1. To remove, use the Test Light Tool or a coin and turn the battery cover counter-clockwise until the
right triangle aligns with the unlock symbol on the Transmitter housing ( 1A).
2. Install two (2), 3-volt (CR2032) batteries positive (+) side up ( 1B).
3. To replace the battery cover, align the right triangle with the unlock symbol, press down and turn
clockwise ( 1C) so that the right triangle aligns with the lock symbol on the Transmitter housing.
To verify the batteries are inserted correctly
1. Press any button on the Remote Transmitter.
2. The Digital Display should activate showing the current correction level.
3. If the Digital Display doesn’t activate, you may have inserted the batteries backwards. Try
taking them out and turning them over, ensuring that the (+) side is up.
4. If the Digital Display still does not activate, contact the Customer Care Center.
Risk of explosion if battery is replaced by an incorrect type. Do not short circuit,
mix old and new batteries, dispose of in fire, or expose to water. When batteries
are stored or disposed, they must be protected from shorting. Dispose of used
batteries properly.
Step 1
1C 1A 1B