Fit the receiver collar, Step – Petsafe Big Dog Remote Trainer User Manual

Page 7

Advertising
background image

12

US Customer Care Center 1-800-732-2677

www.petsafe.net

13

Receiver Indicator Light – Function and Response

Receiver Collar Function

Green LED Response

Power on

Flashes once

Normal operation - Good battery

1 flash every 5 seconds

Training tone

On length of button press

Pairing Complete

Flashes twice

Receiver Collar Function

Red LED Response

Power off

On for 3 seconds

Normal operation - Low battery

3 flashes every 5 seconds

Static stimulation

On length of button press

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is

important for effective training. The Contact Points must have direct

contact with your pet’s skin on the underside of his neck.
To assure a proper fit, please follow these steps:

1. Make sure that the Receiver Collar is turned off.
2. Have your pet standing comfortably

(3A).

3A

3. Place the Receiver Collar on your dog’s neck close to the

ears. Center the Contact Points underneath your dog’s neck,

touching the skin. Note: It is sometimes necessary to trim

the hair around the Contact Points to make sure that contact

is consistent. Longer Contact Points are available from the

Customer Care Center.

Do not shave the pet’s neck as this

may increase the risk of skin irritation.

4. The Receiver Collar should fit snugly, yet loose enough

to allow one finger to fit between the strap and your pet’s

neck (

3C).

5. Allow your pet to wear the collar for several minutes then

recheck the fit. Check the fit again as your pet becomes

more comfortable with the Receiver Collar.

3C

3B

Step

3

6. Trim the collar as follows (

3D):

a. Mark the desired length of the collar with a pen. Allow for

growth if your pet is young or grows a thick winter coat.

b. Remove the Receiver Collar from your pet and cut off

the excess.

Important: Do not cut the part of the

collar containing the Antenna on the PDT00-13410

Little Dog Remote Trainer.

c. Before placing the Receiver Collar back onto your pet,

seal the edge of the cut collar by applying a flame along

the frayed edge.

3D

Risk of skin damage. For comfort, safety and effectiveness of this product, please ensure

that you check the fit of your pet’s collar frequently. If any skin irritation is observed,

discontinue the use of the collar for a few days. If the condition persists beyond 48 hours,

see your veterinarian.
Do not attach a leash to the Remote Trainer. This can result in pulling the Contact Points

too tightly against your pets neck. You may put a separate non-metallic collar on your

dog’s neck and attach a leash. Do use a harness for attaching a leash and/or tags while

using the Remote Trainer.
Please refer to page 2 for additional information.

To Re-Thread the Collar

Ridges

Slide Buckle

The slide buckle prevents the collar from

becoming loose around your pet’s neck.

The ridges must be facing up; the collar will slip if

it is not properly threaded.

Advertising
This manual is related to the following products: