Petsafe Elite Pendant™ Remote Trainer - Manual (Page 11)

www.petsafe.net 11
2. If your pet shows no reaction, repeat the stimulation level several times before moving up to
Low Stimulation Levels 2 and 3.
3. If your pet shows no reaction on Low Stimulation Levels 1, 2, or 3, move the slide switch to
Medium, press the Stimulation 1 button continuously for 1 to 2 seconds.
4. If your pet shows no reaction, repeat the stimulation level several time before moving up to
Medium Stimulation Levels 2 and 3.
5. YOUR PET SHOULD NOT VOCALIZE OR PANIC WHEN RECEIVING STIMULATION. IF THIS
HAPPENS, THE STIMULATION LEVEL IS TOO HIGH AND YOU NEED TO GO BACK TO THE
PREVIOUS LEVEL AND REPEAT THE PROCESS.
6. Move up through the stimulation levels until your pet reliably responds to the stimulation.
7. If you have moved the slide switch to High and your pet continues to show not response,
check the fit of the Pendant ™ . Then go back to #1 and repeat the process. If this still does not
yield any results, your pet’s hair may need to be trimmed around the Contact Loops.
If all of these steps have been done and your pet continues to show no reaction to the stimulation,
see the “Test Light Instructions” section.
If after completing all of these steps your dog still does not indicate he is feeling the stimulation,
please contact Customer Care Center or visit our website at www.petsafe.net.
Teaching Basic Obedience
The “Sit” Command
1. Put a separate, non-metallic collar on your pet’s neck ABOVE the Pendant ™ , and attach a
10-foot leash. Note: Be sure the extra collar does not put pressure on the Contact Loops.
2. Hold the leash and the Handheld Remote in one hand. Keep your other hand free to guide
your pet into a “Sit” position.
3. Using the Recognition Level for your pet, press and hold the Stimulation button.
4. Immediately give the “Sit” command while continuing to hold the Stimulation button.
5. Release the Stimulation button as soon as your pet is in position, and praise him.
6. Release your pet from the “Sit” command and play.
7. Repeat Steps 2 through 6.
Note: If your pet breaks the “Sit” command, repeat steps 3 through 6. Keep your pet close to
you while teaching the “Sit” command.