Petsafe Elite Pendant™ Remote Trainer - Manual (Page 7)

www.petsafe.net 7
3. Charge the Pendant ™ until the green LED comes on and is solid. Recharges take only 3-4 hours
4. When charging is completed, replace the rubber cover.
Attach the Pendant
™
Receiver to a Collar
A black nylon collar is included or most collars up to ¾” wide
can be used with the Pendant ™ .
A non-metallic collar is recommended. If
using a metallic collar ensure it does not
make contact with the Pendant ™ Receiver.
Place Pendant ™ Receiver face down on a hard surface (i.e.
table). Insert collar into loops and rotate through. Ensure
collar is in the inner loop ( 2B).
To Turn the Pendant ™ On
1. Press and hold the SmartTouch On/Off buttons ( 2C) until the
green LED comes on and the Pendant ™ beeps low to high.
2. Release the SmartTouch On/Off buttons. The green LED will flash once
every 10 seconds until the Pendant ™ is turned off. The flashing light
indicates the battery status and that the Pendant ™ is ready to receive a
radio signal from the Handheld Remote.
3. Once the Pendant ™ has been turned on, press the Tone button of the
Handheld Remote. Upon pressing, the Pendant ™ should beep for as
long as the Tone button is pressed. If it does not, see “To Pair the
Handheld Remote and the Pendant ™ Receiver”. Note: To extend the
life of the battery, turn the Pendant ™ off when it is not in use.
To Turn the Pendant
™
Off
1. Press and hold the SmartTouch On/Off buttons ( 2C) until the red LED
turns off (approximately 3 seconds) and the Pendant ™ beeps high to low.
2. Release the SmartTouch On/Off buttons. To extend the life between
charging cycles, turn the Pendant ™ off when it is not in use. Approximate
battery life between charges is 40-50 hours, depending on frequency of use.
Pendant
™
Receiver LED – Function and Response
Pendant ™ Function Status Gauge LED Response Pendant ™ Tone Response
Pendant ™ is turning ON Green LED appears momentarily Beeps low to high
Good battery 3 green LEDs flash every 10 seconds None
Medium battery 2 green LEDs flash every 10 seconds None
Low battery 1 green LED flashes every 10 seconds None
Critical battery condition Red LED flashes three times every 10 seconds None
Tone being received Green LED flashes Tone beep
Pendant ™ is turning OFF Red LED appears for 3 seconds Beeps high to low
Pendant ™ is charging Red LED is solid None
Pendant ™ charging complete Green LED is solid None
Charger
connector
placed in the
Pendant ™
Receiver Micro
USB Port
2A
2B
2C