Petsafe ScoopFree Original Self-Cleaning Litter Box - Manual (Page 11)

Don’t forget to register your ScoopFree

Litter Box at www.scoopfree.com
11
Care and Cleaning
ScoopFree seldom needs cleaning because of its revolutionary
design; surfaces most likely to get soiled are discarded with each
litter tray. Nevertheless, you may occasionally choose to clean
ScoopFree as follows:
• Remove power cord from litter box.
• Remove waste trap lid by tilting it outwards until it falls out of its slots.
• Wipe all surfaces with mild soap and water.
• Wipe rake with sponge or soft brush.
• Make sure optical sensors are not blocked.
• Do not immerse ScoopFree in water or spray it down.
• Do not expose ScoopFree to excessive sunlight or moisture.
Troubleshooting
Issue Remedy
Indicator light is
flashing rapidly,
and
Rake is at the
home position Check if waste trap is full. If so, replace litter tray.
Check for obstructions and remove if necessary.
Make sure magnets on waste cover are properly attached to
litter tray. If not, lift waste cover and lower it back down; you
should hear a “click” when correctly attached to the tray.
Make sure waste trap lid is properly installed.
Ensure litter box is seated properly on litter tray.
Ensure litter box is level.
Ensure litter is evenly distributed. Never add extra litter.
Press the Cycle Button to start a manual raking cycle. When
the rake returns to the home position, the indicator light will
glow steady green.
To re-attach waste trap
lid,
position as shown,
then slide pins into the
slots and rotate down.