Cisco 3600 Series - Manual (Page 8)

8
Note Make sure you use the correct standoff with your AIM. Refer to Figure 8 to determine the correct standoff for your
AIM.
Figure 8 Standoff Orientation
Step 5 Plug the AIM into the AIM connector on the system board. (See Figure 9.) Make sure that the plastic standoff fits into
the hole in the AIM board and that the AIM is fully seated in the connector.
Step 6 Insert the screws (from the mounting kit) through the AIM into the metal standoffs. (See Figure 9.)
Step 7 Check that the AIM is installed correctly on the system board. (See Figure 10.)
1
Plastic standoff for use with new
Cisco 2600 series routers.
4
Plastic standoff for use with legacy
Cisco 2600 series routers.
7
Plastic standoff for use with Cisco
3600 and Cisco 3700 series routers.
2
Metal standoff for use with new
Cisco 2600 series routers.
5
Metal standoff for use with legacy
Cisco 2600 series routers.
8
Metal standoff for use with Cisco
3600 and Cisco 3700 series routers.
3
M-3 type screw for use with new
Cisco 2600 series routers.
6
6/32 in. screw for use with legacy
Cisco 2600 series routers.
9
M-3 type screw for use with Cisco
3600 and Cisco 3700 series routers.
117462
1
5 2
4
3 6
8
7
9