Ryobi RY60514 - Manual (Page 11)

11
ADDiNG FUEL TO cULTivATOR
See Figure 7.
When adding fuel to the cultivator, make sure the unit is sit-
ting on level ground and that the engine is not hot.
Fuel only with recommended 50:1 mixture of gasoline and
lubricant as described in
Mixing the Fuel.
To add fuel to the cultivator:

Clean area around fuel tank cap, if necessary.
 Remove the fuel tank cap.
 Insert a clean funnel into the fuel tank.
 Slowly pour gasoline/lubricant mixture into fuel tank.
NOTE: Fill tank no higher than 1/ in. from top to allow
for gasoline expansion.
 Reinstall fuel cap.
 Clean up any spills.
FUEL TANK
CAP
Fig. 7
ASSEMBLY
ADDiNG SAND
See Figure 8.
The cultivator is equipped with a Just Add Sand
™ weight
system, which improves the stability of the unit during op-
eration. The added weight of the sand also helps you work
with less effort and vibration.
To add sand:

Lift the lid of the Just Add Sand ™ tank and remove.
 Pour dry sand into the tank. The tank will hold approxi-
mately 13 pounds of sand.
NOTE: Be careful not to pour sand into or onto the engine
housing.
 Replace Just Add Sand ™ lid.
Fig. 8
JUST ADD SAND ™
LID