Assembly – Ryobi RY60514 User Manual
Page 8
8
WARNiNG:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
POSiTiONiNG THE HANDLEBAR
See Figure 2.
Loosen the two handlebar knobs.
Unfold the handlebar into operating position.
NOTE: Do not use force. If there is binding, continue to
loosen the knobs. Do not allow throttle cable to become
pinched when raising the handlebar.
Retighten the handlebar knobs.
UNPAcKiNG
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PAcKiNG LiST
Cultivator
Drag Bar
Pull Pin
Hitch Pins ()
Felt Washers ()
Inner Tines ()
Outer Tines ()
Ryobi Exact Mix -Cycle Lubricant
Wheel Assembly (Accessory)
Operator’s Manual
WARNiNG:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
WARNiNG:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
ASSEMBLY
Fig.
HANDLEBAR
HANDLEBAR
KNOBS