Satellite Tufway - Manual (Page 2)

PN 10900/REV P Page 1
INTRODUCTION
These Assembly Instructions cover the Tufway portable restroom. Satellite portable restrooms must be assembled
according to approved assembly procedures. Avoid variations in assembly which could adversely affect product life.
IMPORTANT: Do not remove shipping screw from door until instructed to in the “Install the Front Assembly” step.
• The assembly procedures are written for assembly of single units. If assembling multiple units, considerable
efficiency can be gained by having a crew working in assembly line fashion.
TOOLS
1. C-CLAMP (SATELLITE PN 11593)
2. DRILL ELEC/CORDLESS
3. 3/8 NUT DRIVER BIT
4. 1/4 DRILL BIT
5. HAMMER
6. BLOCK OF WOOD 2X1-1/2 X 6
7. HAND RIVETING TOOL (SATELLITE PN 15814)
8. DEBURRING TOOL
9. #2 PHILLIPS SCREWDRIVER OR BIT
10. 5/16 DRILL BIT
11. APRONS (CARPENTERS)
12. 1/2 WRENCH OR SOCKET AND RACHET SET
HELPFUL HINTS
• Keep panels out of direct sunlight
• Have an apron with at least two large pockets, easy to get parts out of
• Don’t open up all your kit boxes. Open up only enough kit boxes to assemble the number of toilets you are currently
working on. KEEP PARTS ORGANIZED.
• Use toilet paper holders for parts bins on multiple unit assembly
•
The door latch can be put on at any time. It may be more efficient to have someone do this early on multiple unit
assembly.