Satellite Mondo - Manual (Page 5)

PN 20340 REV G Page 4
TIP BASE UP AND POSITION INSIDE PANELS. USING THE DRILL AND 3/8" HEX DRIVER BIT.
FASTEN PANELS TO BASE WITH LAG SCREWS (PN 13860).
ROTOMOLDED BASE: LOCATE DIMPLES CIRCLED ON BASE AT LOCATION SHOWN. FASTEN
PANELS TO BASE WITH LAG SCREWS. FASTEN REMAINING HOLE.
DIRT BUSTER BASE:
FASTEN REAR PANEL FIRST. PANEL NEEDS TO BE FLUSH WITH TOP OF
RUNNER. USING THE CENTER SCRIBE LINE ON BASE FASTEN PANEL WITH LAG SCREW.
REPEAT ON EACH SIDE PANEL USING BOTTOM HOLES. SEE SCRIBE LINE LOCATION AS
SHOWN. FASTEN REMAINING HOLES. NOTE: MAKE SURE PANEL IS FLUSH WITH BASE
BEFORE FASTENING PANEL TO BASE.
ROTOMOLDED BASE DIRT BUSTER BASE
3. ATTACH ROOF TO PANELS
POSITION ROOF OVER PANELS. INSTALL ALL RIVETS AND WASHERS USING THE AIR RIVET GUN;
MAKE SURE ALL RIVETS AND WASHERS ARE TIGHT.
STAND UNIT UP ON BASE FOR THE NEXT ASSEMBLY STEPS