Satellite Mondo - Manual (Page 8)

PN 20340 REV G Page 7
ROTOMOLDED BASE: INSTALL THE NUT AND BOLT IN 2 ND HOLE ON LEFT FACING THROUGH
HOLE BASE. (SEE PICTURE) BEFORE TIGHTENING CHECK REMAINING SCREW HOLES ON FRONT
TO SEE IF THEY LINE UP WITH CORED HOLES IN BASE. IF SO CONTINUE, TIGHTEN BOLT USING
3/8 DRIVER BIT WHILE HOLDING NUT WITH A 1/2" WRENCH. IF NOT USING A 13/32 DRILL BIT
ENLARGE HOLES IN FRONT. INSTALL THE LAG SCREWS USING THE 3/8 NUT DRIVER BIT.
REMOVE SHIPPINGS CREW. OPEN DOOR AND INSTALL THE (2) LAG SCREWS TO DIMPLES TO
INSIDE THE FACING FRAME. (TIGHTEN LAG SCREW UNTIL RUBBER WASHER BEGINS TO
FLATTEN – DO NOT OVER TIGHTEN.) SEE NEXT PAGE FOR DIRT BUSTER BASE.
ROTOMOLDED BASE
DIRT BUSTER BASE: INSTALL LAG SCREWS USING A 3/8 NUT DRIVER BIT AND DRILL.
FASTEN SCREWS IN HOLES CLOSEST TO DOOR OPENING. MEASURE 2-1/4 FROM THAT
SCREW AND FASTEN SECOND SCREWS IN NEW LOCATION. SEE PICTURE.
REMOVE SHIPPING SCREW. OPEN DOOR AND INSTALL THE (2) LAG SCREWS TO DIMPLES T0
INSIDE THE FACING FRAME. (TIGHTEN LAG SCREW UNTIL RUBBER WASHER BEGINS TO
FLATTEN - DO NOT OVER TIGHEN).
DIRT BUSTER BASE
11
.
INSTALL DOOR LATCH
USING A PHILLIPS SCREWDRIVER INSTALL (4) #10 SCREWS THROUGH LATCH IN DOOR ASSY.