V.I.O. POV.HD User Manual User Manual
Page 8
POV.HD User Manual
Get Ready
5
2. Remove the Input/Output cover from the bottom of the recorder, and install the SDHC card included
with the POV.HD.
• Unscrew
the
retaining
screw.
• The
Input/Output
cover
has
a
snug,
water-‐tight
fit.
To
remove
the
cover,
use
a
coin
or
small
flat
bladed
screwdriver
to
pry
at
either
of
the
two
arrows
on
the
cover.
DO
NOT
try
to
remove
the
cover
by
pulling
on
the
retaining
screw.
• Insert the SDHC card into the card slot, until the card latches. If the recorder has been placed face
down as shown, the SDHC card label will face upward when it is inserted correctly.
• Note that the SDHC card has a beveled corner on the leading edge. If you insert the SDHC card
upside
down,
the
square
corner
will
prevent
the
card
from
being
fully
inserted.
DO
NOT
force
the
card.
If
it
will
not
go
all
the
way
into
the
slot,
remove
the
card
and
make
certain
the
label
is
visible
and
the
beveled
corner
is
to
the
right.
• To remove the SDHC card when it is latched, push the back edge of the card slightly and it will
unlatch
and
project
out
a
short
distance.
It
can
then
be
pulled
out.
There
is
a
small
notch
on
the
outer
edge
of
the
label
side
of
the
SDHC
card
that
allows
you
to
use
a
finger
nail
to
slide
the
card
out
after
it
is
unlatched.
• Replace the Input/Output cover and tighten the retaining screw finger tight.
Note:
The
POV.HD
comes
with
a
4
GB
SDHC
card.
The
POV.HD
can
use
SDHC
cards
up
to
32
GB
maximum.
3. Protect the recorder’s LCD screen
To
help
protect
the
POV.HD
recorder’s
LCD
screen
from
scratches
the
POV.HD
comes
with
an
LCD
protective
cover,
which
is
a
small
plastic
sheet
that
is
used
to
cover
the
screen.
To
install
the
LCD
protective
cover:
• The POV.HD is shipped with a temporary plastic film that protects the screen during manufacture
and shipping. If this is still on the unit remove it.
• Make
sure
the
LCD
screen
is
clean
and
free
of
any
dust,
smudges,
fingerprints,
and
goo.
• Peel
the
paper
off
the
back
of
the
film
and
position
the
plastic
sheet
over
the
LCD
screen
and
press it down to secure it.
• Use your finger to smooth out any air bubbles that may be trapped under the cover.