Sangean ATS-909X w (R1) - Manual (Page 25)

24
GB
EXCHANGING STATION POSITIONS IN MEMORY
To move a station, in memory to another position recall station.
Press Memo button, MEMO and position display will flash, press
new position desired and a signal will be heard indicating the
exchange has taken place and the positions have been swapped.
SELECTING AN SW BAND
To select an SW Band, press METER/SW button once and then
press a second time. A flashing m will appear in the display. Any
of the 4 SW bands (-20m) can now be selected using the
numerical keys on the key pad. The band selected appears in the
LCD display and will remain in the display as long as tuning activity
remains within the metered band.
To start Auto Scan Tuning, select an SW band to tune, press one of
the Tuning Up/Down buttons for more than 0.5 second. Once scan
starts, release the button. The Auto Scan stops as soon as an SW
station of adequate signal strength is located. Repeat operation to
start scan again. Scan can be halted by pressing the Tuning Up/
Down buttons momentarily any time during the scanning process.
The range scan for SW station is being circulated as a loop within
the meter band unless you continue pressing the one of the Tuning
Up/Down buttons till the frequency across out of the meter band
range.
To manually tune to a frequency of your choice repeatedly, press
and release one of the Tuning Up/Down buttons until the frequency
desired is displayed.