Sangean ATS-909X w (R1) - Manual (Page 28)

27
ALARM FUNCTION
The ATS-909X has three timer circuits as indicated by TIMER
buttons. The alarm functions may be set with the power on or off.
To set the alarm, press one of the three TIMER buttons. The timer
and button number will flash in the LCD display along with the icon
indicating radio or buzzer for approximately 2 seconds. Select
radio or buzzer by pressing (SSB)/RDS/Alarm mode button. While
flashing continues, you may set time (hours and minutes) for alarm
using the numerical keys on the key pad. When complete press
Enter Selection button. When the sounds beep it means the alarm
has been activated. Repeat steps for other timers.
Note:
If you select the buzzer as your alarm, once it is active, the volume
will not be adjustable but by HWS (Human Wake System), which
makes the alarm bell go from soft to loud. If you select the radio as
your alarm, once it is active, the volume will be adjustable by the
volume control.