BendixKing CNI 5000 - Manual (Page 7)

Channel Mode.
The Channel Mode is used to recall
preset frequencies stored in memory.
1. To enter the Channel Mode, momentarily
push the channel (CHAN) button while in
the Frequency Mode. The active frequency
remains displayed in the “USE” window,
and the last used channel number and its
associated frequency are displayed in the
“CHAN” and “STBY” windows.
If no channels have been programmed,
channel 1 automatically disappears and
dashes are displayed in the “STBY” window.
2.Turn either frequency selection knob to
change the channel number and the chan-
nel’s corresponding frequency in the
“STBY” window.
3. If there is no activity for five seconds, the
radio will exit the Channel Mode and return
to the Frequency Mode, with the channel
frequency remaining in the “STBY” window.
4.You can also return to the Frequency
Mode by either:
a. Pressing the channel button before the
five-second delay, in which case the radio
recalls the “USE” and “STBY” frequencies
prior to entering the Channel Mode, or
b. Pressing the transfer button, so that the
channel frequency becomes the active fre-
quency and the last “USE” frequency
becomes the new “STBY” frequency.
Note: If the optional remote channel incre-
ment switch is installed, each activation of
the switch will put the unit in the Channel
Mode and advance the channel number
from the previous channel used.
Direct Tune Mode.
The Direct Tune Mode is entered by
pressing and holding the transfer button for
longer than two seconds. The “STBY” fre-
quency will disappear and the frequency in
the active window can be changed with the
frequency selection knobs.
Momentarily pushing the transfer button
will return the unit to the Frequency Mode
(normal operation). The “STBY” frequency
displayed prior to entering the Direct Tune
Mode will return unchanged.
Default Mode.
Turning on the COMM radio while
pressing the transfer button will bring the
unit up in the Direct Tune Mode and install
120.00 MHz (120.000 MHz on optional
8.33 kHz COMM) as the active frequency.
This will aid the pilot in blind tuning the
radio in the unlikely event of display failure.
Display Adjust Mode.
To enter the Display Adjust Mode,
press and hold the channel button until the
Program Mode is entered. Continue hold-
ing the channel button while simultaneously
pressing and holding the frequency transfer
button until “dA 1” replaces the frequency
in the “USE” window.
The frequency selector knobs are used to
change the value in the “STBY” window.
Momentarily pressing the channel button
steps the unit through the Display Adjust
6
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN
OFF
PULL
TEST
USE STBY
COMM 1
T
CHAN PULL
25K
CHAN