BendixKing KMD 150 - Pilots Guide - Manual (Page 68)

54
Rev 2 Oct/2002 KMD 150 Pilot's Guide
If Key 1, PREV PAGE, is pressed to discontinue the selection process
the unit will return to whichever the previous Screen was, either Screen
12, Flight Plan Program/Edit Screen, or Screen 38, Map Mode.
This Screen allows you to
select a DIRECT TO spe-
cific latitude and longi-
tude, and is reached by
pressing Key 5 Temp
Wpt on Screen 13.
Use the joystick to enter
the latitude and longitude
of the destination then
press Key 2, ENTER,
and Screen 47, Map
Mode with Navigation
Information, will appear
with DIRECT TO OFF on
Key 5.
SELECTING ITEM
FROM CHOSEN DATA-
BASE
On entry to this Screen
you will find the cursor
positioned over the first
letter of the first item in
the selected database.
If AIRPORTS, VORs,
NDBs, INTs or AIRWAYS
was selected on Screen
13, the first item in the
data entry box on screen
16 is AREA:. This is an area filter that can be set to a specific ICAO
country or area code. If set to EG for example, only items in British air-
space will appear in the list. Similarly, if set to LF, only items in French
airspace will be displayed. In the USA, the airspace is sub-divided into
seven areas known as K1 - K7. The area filter can again be set to any of
these areas (see Appendix 2 for a full list of country and area codes).
If the area filter is set to ALL, all the data from the selected database
contained on the database card for the entire area covered will appear in
the list.
Flight Planning Screens
Screen 15: Temporary Waypoint Input
Screen
Screen 16: Item Selection Screen