CANOGA PERKINS L322 Fast Ethernet Media Converter - Manual (Page 25)

EdgeAccess Universal Chassis System
L322 Fast Ethernet Media Converters 4-7
Table 4. System Configuration Option Definitions
Selection Description
1) Reset Unit Reset only the CLIM
2) Reset Configuration To
Default Restore the factory settings
3) Option Control Set control to hardware or software for RMTF/LLE, Link Loss
Fwd, and Alarm Output
4) RMTF/LLE Enable RMTF or LLE or disable both
5) LLF Enable LLF direction
6) Alarm Output Set Alarm Output
4.6 Trap Configuration
Traps are messages to alert network management about software conditions. The DMM logs the
traps and transmits them by SNMP to the network manager. At the Trap Configuration screen, enable
or disable traps individually or use the "Master Trap Control" to enable or disable all traps. See
Figure 13.
To configure traps:
Step 1. From the Main Menu, type "2," Trap Configuration and press <Enter>.
Step 2. At the Trap Configuration screen, select the number for a trap and press <Enter>.
Note: "Master Trap Control" enables or disables all traps. The factory default is Disabled.
Step 3. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
Figure 13. Trap Configuration Screen