CANOGA PERKINS 9145 Network Interface Device - Manual (Page 20)

3-2 9145 Network Interface Device
Setting Up SNMP Network Management
Typically, the 9145 communicates with CanogaView or your Network Management
Platform in-band via the transported Ethernet Network.
Network Management Platform Set-up
Industry standard Management Information Bases (MIBs) are required on your Network
Management Platform in order to successfully communication with the 9145 using
SNMP. Before you start, check that these industry-standard MIBs are loaded:
1. Standard MIB
2. Dot2sd.mib
3. Etherlike.mib
4. If.mib
5. Bridge.mib
6. Pbridge.mib
Additionally, Canoga Perkins Private MIBs are need on the Management Platform. The
Canoga Perkins Private MIBs are available on Canoga Perkins web site,
www.canoga.com . The MIBs are located in a password protected area of the Web Site.
If you do not yet have a Canoga Perkins Username and Password, please contact Tech
Support.
1. Cp.mib: Supports all Canoga Perkins products
2. Cpsysinf.mib: Supports SNMP access
3. Cphost.mib: Supports Host Table and Host Access functions
4. Cptraptb.mib: Supports the Trap Table
9145 Set-up
There are several TCP/IP and SNMP parameters that need configuration before
accessing the 9145 from CanogaView or your Management Platform. These
parameters include TCP/IP Address, Authorized Host list and privileges. These
parameters are initially using VT-100 Terminal on the RS-232 Serial Port. Please see
the System Configuration section for details on configuring these parameters.