Leica Geosystems Leica DISTO D3a BT - Manual (Page 18)

18 Functions Leica DISTO™ D3a BT 776750 gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ
value is adopted. Aim at the lower point and
press this button to trigger the measurement
(3). The result is displayed in the summary line, the
partial results in the secondary lines.
Indirect measurement - determining a chain
value using 3 measurements
e.g. determining the height between point 1 and
point 2 using three target points.
Press this button six times; the display shows
the following symbol . The laser is switched on.
Aim at the upper point (1).
Press this button and trigger the measurement.
After the first measurement the value is adopted. The
display flashes (2).
Triggers the measurement. After the second
measurement the value is adopted. The display
flashes (3).
Press and hold down this button to trigger
continuous measurement. Sweep the laser up and
down over the ideal target point.
Press this button to end continuous measure-
ment. The result is displayed in the summary line, the
partial results in the secondary lines.
Storage of constants/historical
storage
Storage of a constant
You can store and recall a frequently used value e.g.
height of a room. Measure the desired distance,
press and hold the
button until the device beeps
to confirm storage.
Recalling the constant
Press this button once to recall the constant
and make it available for further calculations by
pressing button
.
Adjusting the constant
Press the button for longer to change the constant
- the constant flashes, you can now change the
1 2
3