Measuring, Functions, Single distance measurement – Leica Geosystems Leica DISTO D8 User Manual
Page 13: Minimum/maximum measurement, Laser continuous ( ), Overview of the program icons
10
Measuring
Leica DISTO™ D8 LCA782206a en
EN
F
E
P
Measuring
Single distance measurement
Press to activate the laser. Press again to trigger the distance measu-
rement.
The result is displayed immediately.
Minimum/maximum measurement
This function allows the user to measure the minimum or maximum
distance from a fixed measuring point. It can also be used to determine
spacings. See figure {I}
This function is commonly used to measure room diagonals (maximum
values) or horizontal distances (minimum values).
Press and hold down this button until you hear a beep. Then slowly
sweep the laser back and forth and up and down over the desired target
point - (e.g. into the corner of a room).
Press to stop continuous measurement. The values for maximum and
minimum distances are shown in the display as well as the last measured
value in the summary line.
Laser continuous (
)
Press and hold down the
key when switching on the device until the
character appears permanently in the display and a beep sounds. Every
further press of the
key releases a distance measurement.
Press the
key and keep it pressed to switch the device and Laser
continuous operation off.
)
If the laser is in continuous operation mode, the device
switches off automatically after 15 minutes.
Functions
Overview of the program icons
Measuring program
Icon Measurement
1 - 2 - 3
Detail display
1 - 2 - 3
Simple distance measu-
rement
Area measurement
Volume measurement
Trapezoid measurement
1 (using three distances)
Trapezoid measurement
2 (using two distances
and one angle)
Pythagorean calculation
1
Pythagorean calculation
2
Pythagorean calculation
3
Inclination measurement
Direct horizontal
distance
Double
tilt measurement 1