Magliner COOLIFT - Manual (Page 11)

1-800-MAGLINE (624-5463) Page 11 www.magliner.com
CooLift
®
Figure 1: CooLift secured under a loaded
pallet with the holding brake engaged
Figure 2: CooLift strapped into truck for transport
D) Unloading a pallet from the Magliner CooLift
1) Position the cart in place on a level surface and engage the holding brake.
2) Lower the deck completely.
3) Unlock the containment strap from the lock by lifting the tab and sliding the latch out.
4) Walk the strap back into position on the roll.
5) Disengage the holding brake by pulling the brake lever back until the latch releases.
E) Transporting the Magliner CooLift inside the truck
Note: It is important to keep the CooLift upright at all times.
1) If you are transporting the CooLift on a truck that has loaded pallets, insert the CooLift
completely under a fully loaded pallet and toggle the up switch until the lift deck makes
contact with the bottom of the pallet but does not lift and engage the holding brake
(Figure 1).
2) If there are no loaded pallets on the truck, the CooLift should be parked next to the wall
and strapped in with the holding brake engaged (Figure 2).
C) Transporting a pallet with the Magliner CooLift
1) When transporting a pallet with the CooLift the operator should always use caution on
natural grades. Be positioned uphill from cart when descending, use brake to control speed
and make no sharp turns.
2) Care should be taken to address any sidewalk ramps or door thresholds to help maintain
stability in the load.
3) Use caution at all sloping or uneven surface areas and make any final positioning changes.
4) Depress the down switch and hold it until the CooLift deck has lowered completely. Note: it
is possible to have the pallet sitting on the floor and the deck still engaged to the bottom of
the pallet if the deck has not been completely lowered.
5) Remove the CooLift from under the pallet.