Panasonic SA-AX6 - Manual (Page 26)

Enjoying sound with DOLBY PRO LOC/C
I
S
K
OFF/ON ■
O O O O
oooo
C) t ) ( )
o O o
O D D o O Q
oo cEl-
QPPg
OOOO
oooo
oooo
oooo
ool^
TEST
TEST
/ /_ /_ r 7
/ / / / /
□n pno LOGIC I -^SpUNCMODE
Speaker channel
— CENTER+
o o
Selected channel
or / ■ / ”/ / 77
T _ / o
□QPPO LOOtC I ^4 SOUND MODE
Output level
- SURROUND+
0.0
I3B
Press TES i to output a test signal.
The speaker outputting the test signal is displayed while the
test is running.
L : Front speaker (Left)
C: Center speaker
R : Front speaker (Right)
S : Surround speakers
For SURROUND mode
L - C - R — S
In the PHANTOM mode, the center speaker is OFF, so there
is no center test signal and “C” is not displayed.
For 3 STEREO mode
L — C - R
Press VOL (“) or (+) to set the volume level
normally used for enjoying the source
The following steps are for setting the output level of the front
speakers and the center/surround speakers to the same listen-
ing level.
by^retri oté: contro I on ly£
Press CENTER (-) or (+), or SURROUND (-) or
(+) to adjust the output level.
Adjust the output level of each speaker from the listening
position until they are all identical.
Decrease the output level.
+: Increase the output level.
Output level can be varied within a range of -12 dB to +12 dB
with front speaker output level serving as the zero point.
1. During step 5 above the lest signal sequence is interrupt­
ed and the signal will only come from the selected speak­
er.
The sequence will resume when adjustments are stopped.
2. Remember you cannot adjust the output level of the sur­
round speakers if you selected the 3 STEREO mode in
step 1.
To stop the test signal
Press TEST.
To turn off the Dolby Pro Logic systems
Press OFF/ON.
Press once again to turn it on,