Panasonic SA-AX6 - Manual (Page 9)

m
VCR {not included) TV (not included)
This receiver has S-VIDEO terminals for a DVD player, VCR (VCR
1 only) and TV,
Equipment connections
Caufion when using a TV v/ith an S-VIDEO terminal
On some television models, the video signal from components
which do not use S-VIDEO input and are connected only to the
VIDEO terminals will not be shown on the television screen.
If this occurs, use one of the following methods to view the video
signal.
Does the television have a
“VJDEO/S-VIDEO” selector
switch?
YES
NO
Set the switch to “VIDEO",
If the television has two or more video input
terminals
Connect the VIDEO terminal and the S-VIDEO
terminal to different video input terminals on the
television, and switch the picture on the televi­
sion according to the video source being
played.
If the television has only one video input ter­
minal
Disconnect the S-VIDEO cable connected to
the television’s S-VlDEO terminal and connect
only the video terminal.
When using S-VIDEO terminals be aware of the following.
Video signals input into the VIDEO terminals cannot be output from
S-VIDEO terminals or vice versa.
Connect this cord after all other cables and cords are connected.
(For areas except Australia and N.Z.)
Set the voltage selector to the voltage setting for the area in which
the unit will be used.
ggTsna
This unit will be seriously damaged if this setting is not made cor­
rectly.
(For areas except Australia and N.Z.)
Insertion of Connector
Even when the connector is perfectly
inserted, depending on the type of
inlet used, the front part of the con­
nector may jut out as shown in the
drawing.
However there is no problem using
the unit. Connector
^ Approx.
"Appliance inlet
(Some areas)
if the power plug wilt not fit your socket, use the power plug adaptor
(included).