Panasonic SC-AK52 EN - Manual (Page 17)

tistemn
0
M contpact discs
Program play
by remote control only
You can program up to 24 tracks.
Press [CD].
Ensure CD is stopped.
Press [PROGRAM].
Press [DISC].
(v\^thin 10 seconds or so)
Press [1] - [5] to select the disc you want.
Press the numeric button to select the desired track.
Repeat steps Q through Q until you have pro­
grammed all the tracks you want.
Press [►/A],
Play will start in the programmed sequence. •
To cancel program play mode
Press [PROGRAM] In the stop mode.
Programmed contents will be saved
in memory.
Pressing p/ CLEAR] will cancel program play, but it will also erase
the entire program.
To select a two-digit track
Press ^10] and then the two numbers you want.
Q When “CD PULL” appears
The number of programmed tracks is limited to 24. No further
tracks can be programmed.
ID You can do the following during program mode
• Check program contents.
Press or [►►»!].
Every time you press one of the buttons, the track and program
No. are shown on the display.
• Add to the program.
Repeat steps Q through Qj.
• Cancel entries.
%
s
I
.S
■a
I
From the last
programmed track Press [CANCEL].
A specified track
only Select the track with or
[►>■/►►1], and press [CANCEL] within
3 seconds.
All tracks Press p/CLEAR].
Memory retention
Your program is retained in memory for about 2 weeks white the
system is unplugged.
To replay your program
If you turned OFF your program with [PROGRAM], you can play it
again as explained below.
1. Press [PROGRAM].
2. Press [►/A].
If you program a track not on your CDs
The track is initially programmed, but during program play, the player
will skip that track and will continue playing from the next programmed
item.