Panasonic RQ-V164 - Manual (Page 2)

Before Operation Tape Playback Listening to the Radio
IS
ET
Power source Q
Insert 2 AA size (R6/LR6 or equivalent, not in­
cluded) batteries.
Batteries installed with incorrect polarities may leak
and damage this unit.
Replace with fresh batteries of the same kind, ob­
serving polarity.
Battery life
When the batteries are weak, the tape speed will
slow down, the sound will become distorted, and
the voiume will decrease.
Connecting the headphones □
Plug the included stereo headphones into the Q
jack.
FAST
Follow steps 1 -4.
• Play will be continued, looping forward and re­
verse side, until STOP is pressed. (Auto reverse)
• You can use normal type of tapes only.
■ To Stop playback
Press STOP.
■ To fast forward and rewind
Press one of the FAST buttons (◄◄ or ►►).
The tape will rapidly move in the direction of the
arrow.
■ To change the tape direction
Press DIR to select the playback side, “FWD” (for­
ward) or “REV” (reverse).
Notes:
• Do not open the cassette compartment cover dur­
ing tape operation.
• If the SELECTOR is set to “RADIO” during tape
operation, the button will not be released even
though the motor has stopped. In this case, press
STOP to release the button.
• Between functions (during play, fast fonward or
rewind), always press STOP first to avoid jam­
ming the tape.
•When the tape reaches the end after fast forward
or rewind, press STOP to release the FAST
button.
Follow steps 1-4.
■ To stop the radio
Set the
SELECTOR to “TAPE CSEB”
■ FM sensitivity selector
Normally set the FM SENS selector to “DX”.
When the FM reception is impaired, or there is
interference from a powerful station, set the selec­
tor to
“LOCAL”.
•This selector does not function for AM reception.
■ Antennas
FM:
Since the headphones cord serves as the FM an­
tenna, be sure to use it extended, not coiled.
AM:
The built-in ferrite core AM antenna is directional.
Turn the unit to obtain optimum reception.
• Be sure to have the set in a horizontal position.
Changing the Tone
■ 3 BAND EQUALIZER
(TREBLE/MID/BASS)
Positioning the control to the “HIGH” side will am­
plify the corresponding controls: the
“LOW" side
will attenuate it.
■ XBS (Extra Bass System) Control
Set this control to “ON” to boost the dynamic bass
range. You can enjoy the dynamic bass sound.
Attaching the belt clip
Belt clip
(included)
Attaching clip to
your belt
To remove