Panasonic PV-8665S - Manual (Page 14)

One Time VCR Setup
^Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again,
When the VCR is turned on for the first time,
it automatically enters the setup mode.
Setup includes the following:
• Choose the language for on-screen menus
and messages.
• Tell the VCR how your equipment is hooked up
(pages 6-9) so the VCR can correctly place
channels into memory.
• Get the VCR ready for clock set.
as ATM ► only. Use the buttons on the VCR for
play, stop, rewind, and fast forward functions.
When a program screen is displayed, the REC, FF,
REW, and PLAY buttons on the remote control and
the VCR function as ATM ► only. (See Timer
Recording Using VCR Buttons on page 23.)
To Set the Language, Cable/DSS
Receiver, Channels and Auto Clock
1
Turn the TV and VCR on/
2
Tune your TV to the VCR output channel (the same
one you set on the back of the VCR: CH3 or CH4).
• if you used audio/video jack connection, tune the TV to its video input.
Press CH A for English
on-screen displays.
Or, press CH
T
for Spanish
on-screen displays.
SELECT U\NGUAGE
PUSH VCR CH A: ENGLISH
OPRIMIR VCR CH T:ESPANOL
APP. VCR/TV : FRANÇAIS
Or, press VCR/TV for French
on-screen displays.
• You can also set the language using the buttons on the VCR.
• If the wrong language is set, see the “Reset all VCR Memory
Functions” section on page 5.
• The VCR should be connected to an antenna or cable box
(page 6-9).
Press
AT
to select your hookup,
and then press ► to set.
• If you selected “CABLE/DSS BOX ►VCR
►TV,” continue with step 5. If not, go to
“Alternate Instructions on page 16.
• If you are using the CABLE/DSS BOX^
VCR/TV connection method, only the
cable box output channel will be placed in memory.
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
VCR^CABLE/DSS B0XA7V
VCRUV
SELECT;* ▼ KEY
SET :► KEY
END lACTION KEY
Press
AT
to select your cable
box or DSS receiver output
channel number,
and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If both a cable box and DSS receiver are used,
set the output channel of the OSS receiver,'
• If you are using Audio/Video jack
connections to your cable box, select and
set “VIDEO OUT as the output channel.
SELECT HOOKUP
CABLE/DSS BOXPVCRPTV
CABLE/DSS BOX OUTPUT CH
SELECT:* ▼ KEY
SET :4 ► KEY
END ;ACTION KEY
Press
AT
to select your cable
box or DSS receiver code number,
and then press ► to enter.
(Refer to the list on page 13.)
• If your cable box or DSS receiver
doesn't have a remote control,
select “NO REMOTE.” Then, go to
Alternate Instructions on page 16.
• This determines whether the VCR will
control your cable box or DSS receiver.
ENTER CODE NUMBER
REFERRING TO MANUAL
SELECT
SET
END * » KEY
► KEY
ACTION KEr
14