Panasonic PV-8665S - Manual (Page 15)

tf you use a cable box,
tune it to channel 02.
If you use a DSS receiver,
tune it to channel 270.
7
Press ► to continue.
• “NOW TRANSMITTING" appears.
If Cable Box
PLEASe TUNE YOUR CABLE
BOX TO CH02.
If DSS Receiver
PLEASE TUNE YOUR DSS
RECEIVER TO CH 270,
PROCEED ;► KEY
END :ACTION KEY
8
Press
AT
to select
“YES” or “NO," and then
press ► to enter.
If Cable Box
tS YOUR CABLE BOX
RECEIVING CH 09 T
SELEC
SET
El
If DSS Receiver
(S YOUR DSS RECEIVER
RECEIVING CH 200?
YES
BE
SELECT ;A^ KEY
SET ;► KEY
END :ACT I ON KEY
If you use a cable box and
selected "YES," go to step 9.
If you use a DSS receiver
and selected "YES," go to
“Alternate Instructions”
on page 16.
If you selected “NO," the screen
in step 6 on page. 14 will reappear. _______________
Try entering a different code
assigned to your brand and/ or
repositioning the equipment (see page 13).
If the answer is stiil “NO," cable box or DSS receiver
controi is not available.
For channel and clock auto set, press ACTION to display
the “SET UP CHANNEL” screen. Then, press AT to select
“AUTO SET." Now, press ► and CH A to start the auto set.
Confirm that your cable box is on
and that your DSS receiver is off.
9
Press
AT
to select your
local PBS channel number
you receive on your cable
box, and then press ^ to
display the “CLOCK AUTO
SET screen.
PLEASE ENTER YOUR LOCAL
PBS CHANNEL ON CABLE BOX
SELECT;A ▼ KEY
SET ;► KEY
END : ACT I ON KEY
10
Press CH
A
to start Auto
Clock Set.
• If you iive near a different time
zone, be sure to enter the PBS
channel in your time zone.
• “AUTO CLOCK SET
PROCEEDING" appears.
CLXK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX, TUNE IT TO YOUR
LOCAL PBS CH THEN, . .
PLEASE PUSH CH UP KEY
11
This display appears when
auto clock set is completed.
Confirm that the time is
correct and press CH
A
to exit.
1/ 4/2000 TUE 12:OOPIi
OST:ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
VD : PUSH CH UP KEY
if the Auto Clock Set
displayed time is incorrect...
If you use a cable box and receive
more than one PBS station, try auto
clock set again.
Follow the “To Set or Reset the Clock"
section on page 17 and when the
instructions call for you to enter a PBS
station, enter the one you have not
tried yet.
If “AUTO CLOCK SET IS
INCOMPLETE” appears...
The screen below will appear on­
screen if auto clock set data is not
available in your area.
AUTO CLOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
Press ACTION to display the “SET
CLOCK" (manual) screen, and
then do steps B and C on page 16.
Note:
If you use a cable box and receive
more than one PBS station, you may
exit the manual clock set screen and
try auto clock set again.
Follow the “To Set or Reset the Clock”
section on page 17 and when the
instructions call for you to enter a PBS
station, enter the one you have not
tried yet.
Auto clock set will be performed when the VCR is turned off the first time each day. If you use a cable box
and you want auto clock set to be performed, the cable box must be left on and tuned to the PBS channel
before the VCR power is turned off.
15